هنوز هیچ رایی ثبت نشده است
ست کامل موتور و درایور دستگاه CNC با قابلیت پشتیبانی از نرم افزار USBCNC
توجه : برد کنترلر دستگاه CNC بدون لایسنس می باشد .
محتویات ست :
1: یک عدد برد کنترلر دستگاه CNC و برش لیزر 3 / 4 محور دارای پورت USB
2: یک عدد ماژول کنترل حرکت ( کی پد ) بردهای کنترلی
3: یک عدد کابل USB
4: چهار عدد استپر موتور 23HD76002Y
5: چهار عدد درایور موتور DM542
Driver Specifications
1. Scope:
The specification applies to 23HD76002Y-30B hybrid stepper motors
2. Type and Size:
2.1 electrical schematic diagram and appearance: See outline drawings
2.2 Drive mode: constant current chopper drive;
2.3 Excitation mode: 2-phase excitation (two-phase four-run shot), you can forward and reverse rotation
2.4 Steering: Press AB-BC-CD-DA sequentially energized from the shaft extension side CW
2.5 rated current (single-phase): 3A DC
2.6 Rated voltage: 3V
2.7 step angle: 1.8 °
2.8 Insulation class: B class insulation
3. Parameters:
3.1 Working conditions: Ambient temperature: -20 ~ 50 ; Relative Humidity: 90% MAX; Mounting position: Shaft horizontal or vertical installation.
3.2 Test conditions (above parameters measured in normal atmospheric conditions test)
3.3 winding DC resistance (25 ): 1Ω ± 10%
3.4 winding inductance: 3.5mH ± 20%
3.5 Positioning Torque: 70mN.m REF.
3.6 Holding Torque (two interlinked rated current): ≥1.8Nm (I = 3A)
3.7 The maximum load starting frequency: ≥1100pps
3.8 The maximum no-load operating frequency: ≥8000pps
3.9 temperature: <80K
3.10 Step Angle Accuracy: 1.8 ° ± 5%
3.11 Moment of inertia: 460g.cm2
3.12 Motor Weight: 1Kg / PC REF.
3.13 Insulation resistance: between the stator core and terminals cold insulation resistance should be greater than 100MΩ (by DC500V megger).
3.14 Dielectric strength: between the stator core and the terminals should be able to withstand AC600V / 1S without breakdown, leakage current of less than 1mA.
Driver Specifications
Extremely cost-effective
Good high speed performance
Supply voltage up to +50VDC
Output current up to 4.2A
Pulse frequency up to 300 KHz
Automatic idle-current reduction
3-state current control technology
Self-adjustment technology
Pure-sinusoidal current control technology
TTL compatible and optically isolated input
15 selectable resolutions in decimal and binary, up to 25,600 steps/rev
Suitable for 2-phase and 4-phase motors
DIP switch current setting with 8 different values
Support PUL/DIR and CW/CCW modes
Short-voltage, over-voltage, over-current protections
Small size (118x75.5x33mm)