ماژول اترنت CH9121 دارای ارتباط سریال

CH9121

5583-122-8961

140,620 تومان
در حال حاضر موجود نمی باشد

موجودی در حال ارسال به انبار


خرید کالا


علاقه مندان : -
وضعیت : فعال

تعداد مرجوعی : 0
دنبال کنندگان : -

قدمت : 8 ماه
وزن : 12 گرم

کل فروش : 5 عدد
تعداد سفارش ها : 1 سفارش

هنوز هیچ رایی ثبت نشده است
ماژول اترنت CH9121 دارای ارتباط سریال

Features:
1) Support TCP / IP protocol: TCP, UDP, ICMP, IPv4, ARP, IGMP
2) Operation mode supports TCP Client, TCP Server and UDP
3) Obtain data serial port and transparent transmission two-way data network
4) Support 10/100 M, full duplex / half-duplex Ethernet self-adjusting interface, compatible with IEEE802.3 protocol
5) Support MDI / MDIX automatic conversion circuit
6) Serial port baud rate of Serial port supports 300bps-921600bps
7) Serial port supports 5.6, 7 or 8 bit data bits and 1 or 2 bit stop bits
8) Serial port supports odd, even, no check, empty 0, mark 1 check way
9) Support DHCP auto get function IP address
10) DNS domain name system support
11) Support 0-2000 ms serial port extraordinary time setting
12) operating mode of Chip, port, IP, serial port baud rate can be configured via upper computer
13) Support virtual serial port

Ethernet:
1) Port Number: 1
2) Standard Interface: -pin RJ45
3) Speed ​​Rate: 10/100 Mbps, MDI / MDIX cross connection auto switch
4) Internet Protocol: TCP, UDP, ICMP, IPv4, ARP, IGMP
5) Protection: KV isolation solenoid

Serial Port:
1) Port Number: 1
2) Interface Standard: TTL
3) Data Bits: 5.6, 7.8 can be set
4) Stop bit: 1.2 can be set
5) Control bit: no; odd check, even check, check mark, control space; can be set
6) Transmission speed: 300bps-921600bps can be set

Software:
1) Configuration Parameter Mode: NetModuleConfig.exe tool

Pin Definition:
1) RXD: serial data input asynchronous serial port
2) TXD: asynchronous serial port for serial data output
3) RSTI: external input reset; low valid level
4) DIR: used for RS485 transceive control
5) RESET: restore the factory settings; ignition chip detection; low valid level
6) GND: common ground leads
7) VIN: power input port; the default value 5 V; when J1 is short circuit connection, input is 3.3